FCC EQUIPMENT FINANCING is selling this:

Peterson 4300

Make
Peterson
Model
4300
Category
Chipper-Pull Type
Year
2010
Location
North America: United States of America
LEXINGTON, SC, USA
Hours
840
Serial Number
43-15-1743
Price
Price on Request

Description

  • The rubber bumpers at top of in-feed throat are worn. One chip drum bearing has had the lower housing replaced - unsure of bearing condition - but is not building excessive heat.
  • 250 hour service was performed at current hours. Machine has a radio remote that works. 2 work lights do not work.
  • Has an auxiliary air compresssor. Battery is missing - it starts and runs well with the pull start. The compressor unloader does not work - it will build air to almost 200 psi then the relief will pop.
  • The access door for the chip accelerator is missing one bolt to secure it (bolt broken off in hole).
  • Tires are in good shape. All trailer lights are intact and brakes work. Light bar is held on with pieces of all-thread . All auxiliary switches (chip deflector - feel roller lift - etc) work.
  • The auxiliary water pump works. The door for access to the water pump/nozzle is dented - but can be opened/closed.
  • Control panel looks good. Fuel level indicator has intermittant fault. Overall machine seems in good condition.
  • This machine is a drum chipper. There is very little vibration. It has new chip accelerator paddles. There are some cracks in belt shrouds and the chip deflector that have been welded back up.
  • Some additional plating/supports were added to the chip deflector. There are still some cracks in sheet metal as seen in the pictures.
  • The mill looks good - has new knives and counter knives. Anvil is worn. In-feed area and drum look good. The chains have a lot of wear for the hours on machine. It has a 3 chain feed system.
  • None